LispForum

Hi. I'm an italian designer and i need some help with lisp programming. I would know if there is a solution for write the layer name in the centre of the top of 3d solid. Thanks!

Looks like you need help on Autolisp for the Autodesk products. I may be wrong, but I believe that this forum does not have many Autolisp programmers following it (I am not one, for example).

You'd be better off looking for some Autolisp specific venue.

Ciao

Marco

There is no built-in support for 3d solids in Common Lisp, or is this AutoLisp? Please ask AutoLisp questions in the Other Dialects section of this forum, as explicitely stated on the Board Index page.