write layer name on solid

Discussion of Common Lisp
Post Reply
trento
Posts: 1
Joined: Fri Nov 21, 2014 1:03 am

write layer name on solid

Post by trento » Fri Nov 21, 2014 1:09 am

Hi. I'm an italian designer and i need some help with lisp programming. I would know if there is a solution for write the layer name in the centre of the top of 3d solid. Thanks!

marcoxa
Posts: 85
Joined: Thu Aug 14, 2008 6:31 pm

Re: write layer name on solid

Post by marcoxa » Sat Dec 06, 2014 10:11 am

Looks like you need help on Autolisp for the Autodesk products. I may be wrong, but I believe that this forum does not have many Autolisp programmers following it (I am not one, for example).

You'd be better off looking for some Autolisp specific venue.

Ciao

Marco
Marco Antoniotti

edgar-rft
Posts: 226
Joined: Fri Aug 06, 2010 6:34 am
Location: Germany

Re: write layer name on solid

Post by edgar-rft » Sat Dec 06, 2014 10:23 am

There is no built-in support for 3d solids in Common Lisp, or is this AutoLisp? Please ask AutoLisp questions in the Other Dialects section of this forum, as explicitely stated on the Board Index page.

Post Reply